EUROLOGIC MAN-FC2000-RAID Podręcznik Użytkownika Pobierz pdf (Strona 21)

Installing a RAID Controller

Chapter 2: Installing a RAID Controller

This section will describe the procedure for installing a

RAID controller into the SANbloc Series. Also, in this

chapter the procedure for upgrading a SANbloc Series from

a JBOD (FC2100) to a RAID (FC2500) system is described.

Installing a RAID Controller

To install a RAID controller, follow this procedure:

The RAID controller is located in the rear of the

enclosure. Follow this procedure to install the RAID

controller.

Installing a RAID

Controller

1 Remove the blank if there is one installed.

2 Gently insert the RAID controller into the slot (see Figure 2-1).

3 Secure in place using the two fixing screws (torque setting

0.3Nm).

4 Connect the cables as described in Chapter 3 of the “SANbloc

Series Installation Guide”.

Figure 2-1 Location of the RAID Controller

RAID Controller

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Brak uwag

EUROLOGIC MAN-FC2000-RAID Podręcznik Użytkownika Strona 21